Diaphragm Metering pump, carcinogens, toxics, pyrofors, and others

DIAPHRAGM METERING PUMPS

Make a note of this pump's F number, also known as its Flow Fluctuation Figure. Use the F number with the % residual fluctuation required figure from the smoothness shown for each type of application. These two figures, the F figure and the % figure, applied to the size selection formula give you the smallest practicable damper size.
See below for figures

OPTIONS:

Go Here for Multiplex Diaphragm Pumps
GO HERE

Go Here to Calculate your VOLUMETRIC & FREQUENCY NEEDS
GO HERE

APPLICATIONS STORIES to:
complimenting Flexorber HP - FLo, GO HERE
complimenting Flexorber LP - SoG, GO HERE
complimenting PipeHuggerLP - PeG, GO HERE
complimenting PipeHugger HP - PHr, GO HERE

Click on the picture or below for complimentary Dampers:
FLEXOBER LP & HP
High & Low Pressure "Flexflon" Damper
PIPEHUGGER LP & HP High & Low Pressure "Flexflon" Damper

Need a Hand? Take this Step by Step Process to help you choose your perfect fitting damper Start Here

Find the "F" Valve of Your Pump - "F" is a correction Factor on the square of number of displacers.
Example, Centrifugals are intrinsically good - have a high F, Sandwich diaphragm metering pumps have a low F.

F = 0.8

F for duplex diaphragm heads also = 0.8
A simplex diaphragm head pump is pushed by a 100 mm diam. piston with a 150 mm stroke @ 205 spm
5 cm Piston Radium x 5 cm pist. rad. x (Pi) 3.142 x 15 cm stroke = 1.18 Liters per stroke @ 3.4 Hz.

Find your % residual fluctuation required figure
from the smoothness shown for each type of application. GO TO

PulseGuard call Toll Free 1-888-DAMPERS (326-7377) or CONTACT US

Selecting Pulsation Dampeners for Different Pump Systems.
Flow through pulsation dampers are at least 3 times more efficient than T off line accumulators.
Dampeners that do, flow goes through, but pressure pulsation does not.
The Smooth Flow People

Call Toll Free 1-888-DAMPERS (326-7377) / See also: Pulsation-Dampeners.com for a pulsation dampener.